Argo AES Series Manual de Instruções descarregar pdf (Página 137)

137

-Modell - 11/12 - Ausgabe 09/11 - 2096161 - BUE-0036-10EN

Appliances

9.2.4 Alde hot-water heater (only Argos 747-2)

The hot-water heater is installed at the bottom of the wardrobe or under the

beds.

Operating unit The operating unit is divided into two sections:

z Display (touch screen)

z Control buttons

Control buttons The control buttons have the following functions:

Display The display (Fig. 144,1) is designed as a touch screen. Touching the symbols

calls up the relevant function.

Start screen The Start screen appears on the display after the heater is switched on. The

Start screen contains the following information:

Z Never run hot-water heater without heating fluid. Observe notes in

chapter 12.

Z Never drill holes in the floor. This might damage the hot-water pipes.

Z The circulating pump must always be turned on when the hot-water heater

is in operation.

Z We recommend to bleed the heating system after the initial heater opera-

tion and to check the glycol content. Observe notes in chapter 12.

Z When the heater is turned on, it starts with the last settings used.

Z For further information, see the separate manufacturer's instruction manual

and observe the maintenance instructions found in chapter 12.

Z For further information about the use of the boiler see section "Boiler".

Fig. 144 Operating unit for hot-water

heater

1 Display (touch screen)

2 "Menu" button

3 On/Off button

Z When no button is pressed, the operating unit automatically switches to

home position after two minutes.

Z Changes to the settings are saved automatically after 10 seconds.

Pos. in

Fig. 144

Button Function

2 MENU Open adjustment menu

Activate heating

1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 261 262

Sem comentários

Argo AES Series Manual de Instruções Página 137