Argo AES Series Manual de Instruções descarregar pdf (Página 47)

-Modell - 11/12 - Ausgabe 09/11 - 2096161 - BUE-0036-10EN

Pitching the motorhome

Extending:  Press the push button for approximately 2 seconds until a brief sound is

emitted. The steady legs control is now activated.

 Press and hold the preselection button for the steady leg side (Fig. 29,2

or 4) for approx. 1 second.

 Within 2 seconds, press the "Extend steady leg" button (Fig. 29,3) and hold

it until the support leg (Fig. 30,4) is touching the ground.

 Press the preselection button for the other steady leg side and repeat the

procedure.

Retracting:

 Press the push button for approx. 2 seconds until a brief sound is emitted.

The steady legs control is now activated.

 Press and hold the preselection button for the steady leg side (Fig. 29,2

or 4) for approx. 1 second.

 Within 2 seconds, press the "Retract steady leg" button (Fig. 29,1) and

hold it until the support leg (Fig. 30,4) is fully retracted. Once the support

leg is fully retracted, a control signal sounds.

 Press the preselection button for the other steady leg side and repeat the

procedure.

Changing the remote

control battery:

 Remove the rear casing.

 Change the battery (CR2032). Observe the correct polarity ("+" to the out-

side).

Emergency operation If the electric drive breaks down, the steady legs can be moved with the hand

crank.

Extending/retracting:

 Press the securing bracket (Fig. 30,2) inwards.

 Push the motor (Fig. 30,3) in the direction indicated as far as it will go.

 Extend or retract the steady leg like a mechanical steady leg via the hex-

agonal nut (Fig. 30,1).

Fig. 30 Electrical steady leg on vehicle

Z Do not extend the steady leg to the end position without it being in contact

with the ground.

Z The battery must be changed if the control LED flashes more slowly or if it

goes out.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 261 262

Sem comentários

Argo AES Series Manual de Instruções Página 47