Argo AES Series Manual de Instruções descarregar pdf (Página 142)

142 A-Modell - 11/12 - Ausgabe 09/11 - 2096161 - BUE-0036-10EN

Appliances

Switching on:  Push the sliding regulator (Fig. 151,1) of the flow control downward to the

desired position. The water circulation is open.

 Turn the fan switch (Fig. 151,2) for the circulation fan in a clockwise direc-

tion.

Switching off:

 Turn the fan switch (Fig. 151,2) to " ".

 Push the sliding regulator (Fig. 151,1) of the flow control upward as far as

it goes.

9.2.6 Electrical floor warming unit (special equipment)

The transformer (Fig. 152,1) for the electrical floor warming unit is installed

either in the bench seat or in the bedding box, depending on the model.

Fig. 151 Operating controls for auxiliary

heat exchanger

X On models with electrical floor warming unit, never drill holes in the floor

or screw in any screws. Careful with sharp objects. There is danger of a

power cut or a short circuit due to damage to a heater wire.

Z Do not cover the transformer. Danger of overheating!

Z The electrical floor warming unit only operates if the vehicle is connected

to the 230 V power supply.

Z The output of the electrical floor warming unit alone is not sufficient to heat

the living area.

Fig. 152 Transformer for electrical floor

warming unit

Fig. 153 Switch for electrical floor

warming unit

1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 261 262

Sem comentários

Argo AES Series Manual de Instruções Página 142